- Motor power of 20 | 25 hp
- Tube Ø 6.3'', ss304
- Tube lengths 13' - 19.7'
- Propeller Ø 21.3'' - 30.7''
- Suitable up to 26.3 ft beneath substrate level. Deeper depths on request
- POM protection to minimize abrasion
- Low-noise spur gear
- Bearing housing with mechanical SiC/SiC seal
- Sealing plates available in 3 sizes in ss304 or ss316
- Sealing membrane EPDM 60
- Oil expansion vessel for lubrication and monitoring of the seal
- Horizontally and vertically adjustment up to ± 30°
- Hydraulic vertical adjustment (optional cylinder support upwards)
- POM protection to minimize abrasion
- Stainless steel rain cover optional
- GIANTMIX FT HY only with PTO drive and without motor possible
Technical data
Type
|
FT4 |
FT4
|
FT5 |
FT5
|
| Propeller speed [rpm] |
330 |
480 |
330 |
480 |
Rated power [hp]
|
20 |
20 |
25 |
25 |
Frequency [Hz]
|
60 |
Propeller [in]
|
29.5 |
21.3 |
30.7 |
22.8 |
| Ex-Zone |
2 |
Dimensions
Further information
Adjustment:The agitator can be inclined horizontally and vertically up to ± 30°. Vertical adjustment by hydraulic unit and lateral adjustment by hand spindle are standard.
Installation depth:
The unique sealing system allows for installation up to 26' below substrate level retaining full swivelling range. Deeper depths on request. The flexible tube leadthrough gets sealed by 2 EPDM sealing membranes (inside and outside) and the special SUMA sealing system.
Optional PTO drive:
The GIANTMIX FT can alternatively be tractor-driven by using an optional protective device. All agitators of the type GIANTMIX FT are available with PTO connection and without motor.
