- Low-noise spur gear
- Bearing housing with mechanical seal of SiC/SiC
- Tube Ø 159 mm, ss304 or ss316 / wall thickness 5 mm
- Tube lengths from 4.0 / 5.0 / 5.5 / 6.0 m
- Sealing plates in 3 sizes in ss304 (V2A) or ss316 (V4A)
- Sealing membrane EPDM 60
- Oil expansion vessel for lubrication and monitoring of the seal
- Suitable up to 8 m beneath substrate level. Deeper depths on request
- Horizontally and vertically inclination adjustment of ± 30°
- Propeller diameters from 660 to 880 mm in ss304 (V2A) stainless or hardened steel
- Hydraulic inclination (optional cylinder support upwards)
- Stainless steel rain covers optional
- POM protection to minimize abrasion
- Giantmix FT HY only with PTO drive and without motor possible
Technical data
Dimensions
Further information
Adjustment options:
The agitator is the only agitator worldwide that can be adjusted ± 30° horizontally and vertically. A high-quality hydraulic unit and a hand spindle are supplied as standard for this purpose.
Depth of use:
Due to the unique sealing system, an installation depth of up to 8 m below the filling level and a full swivelling range are possible.
The flexible pipe penetration is sealed with two EPDM sealing membranes (inside and outside) with a ball in between.
Deeper installation depths are also possible on request.
Optional tractor drive:
The GIANTMIX FT can be driven by a tractor with an optional protective device. All GIANTMIX FT mixers are also available without a motor and only with a PTO connection as FT HY.
